OMAX MICROMAX PRECISION
The MicroMAX Jet Machining Center is the ideal solution for ultra-precision abrasive waterjet machining. Utilizing advanced high-precision optical linear encoders, innovative vibration isolation, and proven software control systems, the MicroMAX Jet Machining Center is capable of a positioning accuracy of less than five microns while retaining all the advantages of abrasive waterjet machining. The MicroMAX can machine stainless steel, titanium, carbon fiber, PEEK, glass, nitinol, graphite, copper, composites, laminates, and more, with high precision and smooth finishing, for either prototyping or production.
| Footprint (with pump & controller) | 10' 2" x 7' 2" (3.10 m x 2.18 m) |
|---|---|
| Height (with whip plumbing) | 7' 6" (2.29 m) |
| Operating Weight | 7,372 lb (3,344 kg) |
| Weight (tank empty) | 3,700 lb (1,678 kg) |
| X-Y Cutting Travel* | 2' 1" x 2' 1" (0.63 m x 0.63 m) |
| Z-Axis Travel (with Motorized Z Axis)* | 4.5" (114 mm) |
| Table Size | 2' 11" x 3' 0" (0.89 m x 0.91 m) |
| Material Supports Slats | 4" x 1/8" Galvanized Steel |
|---|---|
| Maximum Supported Material Load | 400 lbs/sq ft (1,950 kg/sq meter) |
| Electrical Requirements | 3-Phase, 380-480 VAC ±10%, 50-60 Hz |
| Speed | 100 in/min (2,540 mm/min) |
| Linear Positional Accuracy* | ±0.0001" (±2.5 micron) |
| Repeatability* | ±0.0001" (±2.5 micron) |
| Ballbar Circularity* | ±0.0005" (±13 microns) |
- Small, efficient footprint for minimal floorspace utilization
- Very high precision with 0.1 micron linear optical encoder system
- Highly rigid structure with low mass bridges and carriages
- Stiff construction greatly reduces vibration and increases accuracy
- Vibration isolation of table and gantries
- All components have matched thermal expansion
- Revolutionary patent-pending process for fine abrasive feed rate
- Full enclosure with environmental controls provides quiet, safe and clean operation below 80db
- Advanced pressure controls for piercing delicate materials
- No heat-affected zones or mechanical stresses
- Standard OMAX 7/15 Mini MAXJET 5 Nozzle acquires finer precision cutting capability with a 0.007" orifice and a 0.015" mixing tube combination
- Standard Tilt-A-Jet taper eliminating abrasivejet cutting head
- Standard Rapid Water Level Control for cleaner, safer, and quieter submerged cutting completes most work below 80 dBA
- Can machine hardened steel as easily as annealed steel
- Easily cut non-conductive and reflective materials
- Leaves behind a satin-smooth edge, reducing secondary operations
- Shipped as a completely pre-assembled and factory-tested system
- Designed and manufactured at the OMAX factory in Kent, Washington, USA
Features and Benefits
- this is a list item
- this is a list item
- this is a list item